Example: The following shows example CLI display output for the command.
(Switch) #show ipv6 brief
IPv6 Forwarding Mode........................... Enable
IPv6 Unicast Routing Mode...................... Enable
IPv6 Hop Limit................................. 0
ICMPv6 Rate Limit Error Interval............... 1000 msec
ICMPv6 Rate Limit Burst Size................... 100 messages
Maximum Routes................................. 3000
show ipv6 interface
Use this command to show the usability status of IPv6 interfaces and whether ICMPv6 Destination
Unreachable messages may be sent.
Format
show ipv6 interface {brief | <unit/slot/port> |tunnel <0-7> | loopback
<0-7>}
Mode
Privileged EXEC
If you use the brief parameter, the following information displays for all configured IPv6
interfaces:
Term
Definition
Interface
The interface in unit/slot/port format.
IPv6 Routing
Shows whether the mode is enabled or disabled.
Operational
Mode
IPv6 Address/
Shows the IPv6 address and length on interfaces with IPv6 enabled.
Length
If you specify an interface, the following information also appears.
Term
Definition
IPv6 is enabled
Appears if IPv6 is enabled on the interface.
Routing Mode
Shows whether IPv6 routing is enabled or disabled.
IPv6 Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
7-21