Ipv6 Pimsm Join-Prune-Interval; Ipv6 Pimsm Register-Threshold - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

Default 30
Format
ipv6 pimsm hello-interval <0-18000>
Mode Interface Config
no ipv6 pimsm hello-interval
This command is used to set the hello interval to the default value.
Format
no ipv6 pimsm hello-interval
Mode Interface Config

ipv6 pimsm join-prune-interval

This command is used to configure the interface join/prune interval for the PIM-SM router. The
join/prune interval is specified in seconds. This parameter can be configured to a value from 0 to
18000.
Default 60
Format
ipv6 pimsm join-prune-interval <0-18000>
Mode Interface Config
no ipv6 pimsm join-prune-interval
Use this command to set the join/prune interval to the default value.
Format
no ipv6 pimsm join-prune-interval
Mode Interface Config

ipv6 pimsm register-threshold

This command configures the Register Threshold rate for the Rendezvous Point router to switch to
a source-specific shortest path. The valid values are from (0 to 2000 kilobits/sec).
IPv6 Multicast Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
6-10