Dot1X Guest-Vlan; Dot1X Initialize - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

Format
clear radius statistics
Mode Privileged EXEC

dot1x guest-vlan

This command configures VLAN as guest vlan on a per port basis. The command specifies an
active VLAN as an IEEE 802.1x guest VLAN. The range is 1 to the maximumVLAN ID
supported by the platform.
Default disabled
Format
dot1x guest-vlan <vlan-id>
Mode Interface Config
no dot1x guest-vlan
This command disables Guest VLAN on the interface.
Default disabled
Format
no dot1x guest-vlan
Mode Interface Config

dot1x initialize

This command begins the initialization sequence on the specified port. This command is only valid
if the control mode for the specified port is "auto" or "mac-based". If the control mode is not 'auto'
or "mac-based", an error will be returned.
Format
dot1x initialize <unit/slot/port>
Mode Privileged EXEC
Switching Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
3-65