Clear Arp-Switch; Show Arp - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

clear arp-switch

Use this command to clear the contents of the switch's Address Resolution Protocol (ARP) table
that contains entries learned through the Management port. To observe whether this command is
successful, ping from the remote system to the DUT. Issue the show arp switch command
to see the ARP entries. Then issue the clear arp-switch command and check the show
arp switch entries. There will be no more arp entries.
Format
clear arp-switch
Mode Privileged EXEC

show arp

This command displays the Address Resolution Protocol (ARP) cache. The displayed results are
not the total ARP entries. To view the total ARP entries, the operator should view the show arp
results in conjunction with the show arp switch results.
Format
show arp
Mode Privileged EXEC
Term Definition
Age Time The time it takes for an ARP entry to age out. This is configurable. Age time is measured
(seconds)
in seconds.
Response Time The time it takes for an ARP request timeout. This value is configurable. Response time
(seconds)
is measured in seconds.
Retries The maximum number of times an ARP request is retried. This value is configurable.
Cache Size The maximum number of entries in the ARP table. This value is configurable.
Dynamic Renew Displays whether the ARP component automatically attempts to renew dynamic ARP
Mode
entries when they age out.
Total Entry Count The total entries in the ARP table and the peak entry count in the ARP table.
Current / Peak
Static Entry Count The static entry count in the ARP table, the active entry count in the ARP table, the
Configured/Active
active entry count in the ARP table, and maximum static entry count in the ARP table.
/ Max
The following are displayed for each ARP entry:
Term Definition
IP Address The IP address of a device on a subnet attached to an existing routing interface.
Routing Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
4-6