Show Ipv6 Ospf Database Database-Summary - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

display the link LSAs. Use network to display the network LSAs. Use nssa-external to display
NSSA external LSAs. Use prefix to display intra-area Prefix LSAs. Use router to display
router LSAs. Use unknown area, unknown as, or unknown link to display unknown
area, AS or link-scope LSAs, respectively. Use <lsid> to specify the link state ID (LSID). Use
adv-router to show the LSAs that are restricted by the advertising router. Use self-
originate to display the LSAs in that are self originated. The information below is only
displayed if OSPF is enabled.
Format
show ipv6 ospf [<areaid>] database [{external | inter-area {prefix |
router} | link | network | nssa-external | prefix | router | unknown
{area | as | link}}] [<lsid>] [{adv-router [<rtrid>] | self-
originate}]
Modes • Privileged EXEC
• User EXEC
For each link-type and area, the following information is displayed.
Term Definition
Link Id A number that uniquely identifies an LSA that a router originates from all other self
originated LSAs of the same LS type.
Adv Router The Advertising Router. Is a 32 bit dotted decimal number representing the LSDB
interface.
Age A number representing the age of the link state advertisement in seconds.
Sequence A number that represents which LSA is more recent.
Checksum The total number LSA checksum.
Options An integer indicating that the LSA receives special handling during routing calculations.
Rtr Opt Router Options are valid for router links only.

show ipv6 ospf database database-summary

Use this command to display the number of each type of LSA in the database and the total number
of LSAs in the database.
Format
show ipv6 ospf database database-summary
Modes • Privileged EXEC
• User EXEC
IPv6 Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
7-60