Snmp-Server Community Rw; Snmp-Server Enable Traps Violation - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

snmp-server community rw

This command restricts access to switch information. The access mode is read/write (also called
private).
Format
snmp-server community rw <name>
Mode Global Config

snmp-server enable traps violation

This command enables the sending of new violation traps designating when a packet with a
disallowed MAC address is received on a locked port.
Note: For other port security commands, see
Default disabled
Format
snmp-server enable traps violation
Mode Interface Config
no snmp-server enable traps violation
This command disables the sending of new violation traps.
Format
no snmp-server enable traps violation
Mode Interface Config
snmp-server enable traps
This command enables the Authentication Flag.
Default enabled
Format
snmp-server enable traps
Mode Global Config
Management Commands
Managed Switch CLI Manual, Release 8.0
"Protected Ports Commands" on page
v1.0, July 2009
3-52.
10-44