NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual page 144

Load-balancing is not supported on every device. The range of options for load-balancing may
vary per device.
Default 3
Format
port-channel load-balance
port> |<all>}
Mode Interface Config
Global Config
Term Definition
1 Source MAC, VLAN, EtherType, and incoming port associated with the packet
2 Destination MAC, VLAN, EtherType, and incoming port associated with the packet
3 Source/Destination MAC, VLAN, EtherType, and incoming port associated with the packet
4 Source IP and Source TCP/UDP fields of the packet
5 Destination IP and Destination TCP/UDP Port fields of the packet
6 Source/Destination IP and source/destination TCP/UDP Port fields of the packet
<unit/slot/ Global Config Mode only: The interface is a logical unit/slot/port number of a configured port-
port>| all
channel. "All" applies the command to all currently configured port-channels.
no port-channel load-balance
This command reverts to the default load balancing configuration.
Format
no port-channel load-balance {<unit/slot/port> | <all>}
Mode Interface Config
Global Config
Term Definition
<unit/slot/ Global Config Mode only: The interface is a logical unit/slot/port number of a configured port-
port>| all
channel. "All" applies the command to all currently configured port-channels.
Switching Commands
Managed Switch CLI Manual, Release 8.0
{ 1 | 2 | 3 | 4 | 5 | 6 } {<unit/slot/
v1.0, July 2009
3-108