Show Spanning-Tree Interface - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

show spanning-tree interface

This command displays the settings and parameters for a specific switch port within the common
and internal spanning tree. The <unit/slot/port> is the desired switch port. The following
details are displayed on execution of the command.
Format
show spanning-tree interface <unit/slot/port>
Mode • Privileged EXEC
• User EXEC
Term
Hello Time
Port Mode
BPDU Guard Effect
Root Guard
Loop Guard
TCN Guard
BPDU Filter Mode
BPDU Flood Mode
Auto Edge
Port Up Time Since
Counters Last Cleared
STP BPDUs
Transmitted
STP BPDUs Received
RSTP BPDUs
Transmitted
RSTP BPDUs Received Rapid Spanning Tree Protocol Bridge Protocol Data Units received.
MSTP BPDUs
Transmitted
MSTP BPDUs Received Multiple Spanning Tree Protocol Bridge Protocol Data Units received.
Switching Commands
Definition
Admin hello time for this port.
Enabled or disabled.
Enabled or disabled.
Enabled or disabled.
Enabled or disabled.
Enable or disable the propagation of received topology change notifications and
topology changes to other ports.
Enabled or disabled.
Enabled or disabled.
To enable or disable the feature that causes a port that has not seen a BPDU for
'edge delay' time, to become an edge port and transition to forwarding faster.
Time since port was reset, displayed in days, hours, minutes, and seconds.
Spanning Tree Protocol Bridge Protocol Data Units sent.
Spanning Tree Protocol Bridge Protocol Data Units received.
Rapid Spanning Tree Protocol Bridge Protocol Data Units sent.
Multiple Spanning Tree Protocol Bridge Protocol Data Units sent.
v1.0, July 2009
Managed Switch CLI Manual, Release 8.0
3-25