Show Sflow Receivers - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

Field Description
Poller Data The sFlowDataSource (slot/port) for this sFlow sampler. This agent will support Physical
Source
ports only.
Receiver Index The sFlowReceiver associated with this sFlow counter poller.
Poller Interval The number of seconds between successive samples of the counters associated with this
data source.

show sflow receivers

Use this command to display configuration information related to the sFlow receivers.
Format
show sflow receivers [<index>]
Mode Privileged EXEC
Field Description
Receiver Index The sFlow Receiver associated with the sampler/poller.
Owner String The identity string for receiver, the entity making use of this sFlowRcvrTable entry.
Time Out The time (in seconds) remaining before the receiver is released and stops sending
samples to sFlow receiver.
Max Datagram The maximum number of bytes that can be sent in a single sFlow datagram.
Size
Port The destination Layer4 UDP port for sFlow datagrams.
IP Address The sFlow receiver IP address.
Address Type The sFlow receiver IP address type. For an IPv4 address, the value is 1 and for an IPv6
address, the value is 2.
Datagram The sFlow protocol version to be used while sending samples to sFlow receiver.
Version
Example: The following shows example CLI display output for the command.
(switch) #show sflow receivers 1
Receiver Index................................. 1
Owner String...................................
Time out....................................... 0
IP Address:.................................... 0.0.0.0
Address Type................................... 1
Port........................................... 6343
Utility Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
9-88