NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual page 722

Table 11-48: PIM-SM Log Messages
Component Message
PIM-SM PIM-SM not initialized
PIM-SM Unable to take xxx semaphore
PIM-SM Warning : Could not send packet type xxx
(pimsm packet type) on rtrIfNum
PIM-SM add_kernel_cache : memory allocation
failed
PIM_SM Config error. Trying to add static RP.
Dynamic RP with same ip addr exists
PIM-SM Inner xxx(source/group) address of register
message is invalid
Table 11-49: PIM-DM Log Messages
Component Message
PIM-DM Out of memory when creating xxx
PIM-DM Error entry->ll_xxx LL creation error
PIM-DM pim_interface_set: Could not give taskSema This message is logged when Task
PIM-DM Error initializing CACHE
Log Messages
Managed Switch CLI Manual, Release 8.0
Cause
This message arises when trying to activate
pimsm interfaces or receiving pimsm
packets when pimsm component is not
initialized.
This message is logged when failed to
acquire semaphore to access source list or
group list or candidate Rp list or virtual
interface list. The xxx specifies the list for
which the access is denied.
this warning is logged when failed to send a
pimsm control packet on the specified router
interface.
This message is logged when there is
insufficient memory to add an mroute entry
into cache.
Router learns RP-group mapping through
Bootstrap messages received.This message
pops when the static RP is configured which
conflicts the mapping learnt dynamically
through Bootstrap messages.
This log message appears when a register
message is received with invalid inner ip
source or group address.
Cause
This message is logged when there is
insufficient memory to accommodate a new
neighbor/(S,G) Entry, Prune, Graft, Join etc.
This message is logged when the SLL
creation is Failed.
synchronization Semaphore release fails.
This message is logged when the PIM-DM
(S,G) entry Cache table initialization fails.
v1.0, July 2009
11-22