Transport Input Telnet; Transport Output Telnet - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

transport input telnet

This command regulates new Telnet sessions. If enabled, new Telnet sessions can be established
until there are no more sessions available. An established session remains active until the session
is ended or an abnormal network error ends the session.
Note: If the Telnet Server Admin Mode is disabled, Telnet sessions cannot be established.
Use the ip telnet server enable command to enable Telnet Server
Admin Mode.
Default enabled
Format
transport input telnet
Mode Line Config
no transport input telnet
Use this command to prevent new Telnet sessions from being established.
Format
no transport input telnet
Mode Line Config

transport output telnet

This command regulates new outbound Telnet connections. If enabled, new outbound Telnet
sessions can be established until the system reaches the maximum number of simultaneous
outbound Telnet sessions allowed. An established session remains active until the session is ended
or an abnormal network error ends it.
Default enabled
Format
transport output telnet
Mode Line Config
Management Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
10-12