Show Interface Loopback - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

no interface loopback
This command removes the loopback interface and associated configuration parameters for the
specified loopback interface.
Format
no interface loopback <loopback-id>
Mode Global Config

show interface loopback

This command displays information about configured loopback interfaces.
Format
show interface loopback [<loopback-id>]
Mode Privileged EXEC
If you do not specify a loopback ID, the following information appears for each loopback interface
on the system:
Term Definition
Loopback ID The loopback ID associated with the rest of the information in the row.
Interface The interface name.
IP Address The IPv4 address of the interface.
Received The number of packets received on this interface.
Packets
Sent Packets The number of packets transmitted from this interface.
IPv6 Address The IPv6 address of this interface.
If you specify a loopback ID, the following information appears:
Term Definition
Interface Link Shows whether the link is up or down.
Status
IP Address The IPv4 address of the interface.
IPv6 is enabled Shows whether IPv6 is enabled on the interface.
(disabled)
IPv6 Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
7-9