NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual page 725

Table 11-52: System General Error Messages
Component Message
OS USL: A Trunk being set doesn't exist in USL Possible synchronization issue between the
OS USL: failed to sync trunk table on unit=x
OS USL: Mcast entry not found on a join
OS USL: Mcast entry not found on a leave
OS USL: failed to sync dvlan data on unit=x
OS USL: failed to sync policy table on unit=x
OS USL: failed to sync VLAN table on unit=x
OS Invalid LAG id x
OS Invalid uport calculated from the BCM uport
bcmx_l2_addr->lport = x
OS Invalid USP calculated from the BCM
uport\nbcmx_l2_addr->lport = x
OS Unable to insert route R/P
OS Unable to Insert host H
OS USL: failed to sync L3 Intf table on unit=x
OS USL: failed to sync L3 Host table on unit=x Could not synchronize unit x due to a
OS USL: failed to sync L3 Route table on unit=x Could not synchronize unit x due to a
Log Messages
Managed Switch CLI Manual, Release 8.0
Cause
application, hardware, and sync layer.
Could not synchronize unit x due to a
transport failure or API issue on remote unit.
A synchronization retry will be issued
Possible synchronization issue between the
application, hardware, and sync layer
Possible synchronization issue between the
application, hardware, and sync layer
Could not synchronize unit x due to a
transport failure or API issue on remote unit.
A synchronization retry will be issued
Could not synchronize unit x due to a
transport failure or API issue on remote unit.
A synchronization retry will be issued
Could not synchronize unit x due to a
transport failure or API issue on remote unit.
A synchronization retry will be issued
Possible synchronization issue between the
BCM driver and HAPI
Uport not valid from BCM driver.
USP not able to be calculated from the learn
event for BCM driver.
Route 'R' with prefix 'P' could not be inserted
in the hardware route table. A retry will be
issued.
Host 'H' could not be inserted in hardware
host table. A retry will be issued.
Could not synchronize unit x due to a
transport failure or API issue on remote unit.
A synchronization retry will be issued
transport failure or API issue on remote unit.
A synchronization retry will be issued
transport failure or API issue on remote unit.
A synchronization retry will be issued
v1.0, July 2009
11-25