Ip Igmp Startup-Query-Count; Ip Igmp Startup-Query-Interval - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

ip igmp startup-query-count

This command sets the number of Queries sent out on startup, separated by the Startup Query
Interval on the interface. The range for <count> is 1 to 20.
Default 2
Format
ip igmp startup-query-count <count>
Mode Interface Config
no ip igmp startup-query-count
This command resets the number of Queries sent out on startup, separated by the Startup Query
Interval on the interface to the default value.
Format
no ip igmp startup-query-count
Mode Interface Config

ip igmp startup-query-interval

This command sets the interval between General Queries sent on startup on the interface. The time
interval value is in seconds. The range for <interval> is 1 to 300 seconds.
Default 31
Format
ip igmp startup-query-interval <interval>
Mode Interface Config
no ip igmp startup-query-interval
This command resets the interval between General Queries sent on startup on the interface to the
default value.
Format
no ip igmp startup-query-interval
Mode Interface Config
IP Multicast Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
5-30