Omron M1 Series User Manual page 727

(All bits are ON or active with 1.)
Bit Symbol
0 FAR1
1 FDT1
2 IRDY
3 SETM
4 IPF
5 THM
6 REF
7 FAN
Example: Running Status 3 Monitor (3003-47 hex) = 0281 hex
02 81 → 0000 0010 1000 0001
Hex Hex
Data Format [45]: Floating Point Data
15 14 13
Exponent
part
Exponent part: 0 to 3, Mantissa part: 0 to 9,999
Value represented in this format = Mantissa part × 10 to the power of (exponent part - 3)
Value
0.000 to 9.999
10.00 to 99.99 1,000 to 9,999
100.0 to 999.9 1,000 to 9,999
1,000 to 9,999 1,000 to 9,999
Example: Data Used Integrating Electric Power (3010-53 hex) = 9,999 kW
9,999 = Mantissa part: 9,999 (270F hex), Exponent part: 2 = A70F hex →
Example: Data Used Integrating Electric Power (3010-53 hex) = 999.9 kW
999.9 = Mantissa part: 9,999 (270F hex), Exponent part: 1 = 670F hex →
Example: Data Used Integrating Electric Power (3010-53 hex) = 99.99 kW
99.99 = Mantissa part: 9,999 (270F hex), Exponent part: 0 = 270F hex →
Data Format [67]: RUN Command Source Monitor
Code
0 Digital Operator positive direction
terminal
1 Terminal command (FW or RV)
2 Digital Operator forward rotation
3 Digital Operator reverse rotation
4 to 20 Reserved
M1 Series EtherCAT Type User's Manual (I670)
Description
Constant speed arrival
Over set Frequency arrival
Operation ready
2nd motor selection
During restart after instantane-
ous power failure
Thermal warning
RUN command source
Fan operation signal
= FAR1, FAN, and OHF are ON
b
12 11 10 9
Mantissa part Exponent part 10 to the power of (exponent part - 3)
0 to 9,999 0
1
2
3
Description
Bit Symbol
8 TRY
9 OHF
10 LIFE
11 OLP
12 OL2
13 LOC
14 OL
15 0
8 7 6 5 4
Mantissa part
0.001
0.01
0.1
1
Same as the selection for RUN Command Selection
(3004-03 hex/301F-03 hex)
Appendices
Description
During retry
Fin Overheat warning
Life warning
During active drive
Overload warning 2
Light load detection
Overload warning
---
3 2 1 0
A7 0F
Hex Hex
67 0F
Hex Hex
27 0F
Hex Hex
Remarks
A
A-181