Omron M1 Series User Manual page 806

Appendices
Event name Operation Error
Meaning Incorrect operation was performed without following the operating instructions.
Source EtherCAT Master Function Mod-
ule
Error attrib- Level
utes
Effects User program
Indicators EtherCAT NET RUN
---
System-de- Variable
fined varia-
None
bles
Cause and Assumed cause
correction
(1) The forced stop signal STOP
(digital input terminal) was turned
OFF.
(2) The brake check signal BRKE
and the brake signal BRKS mis-
match.
Attached in- None
formation
Precautions/ None
Remarks
A-260
Source details Slave
Minor fault Recovery
Continues. Operation
EtherCAT NET ERR
---
Data type
None
Correction
Check if the forced stop signal
STOP is turned OFF.
→ If the inverter performs unin-
tended operation, review the set-
tings of Terminal [DI] function
selection (3005-02 to 06 hex, 63
hex, and 64 hex).
Check if the signal input to the
multi-function input terminal to
which the brake check signal
BRKE is assigned matches the
brake signal BRKS output from
the multi-function output terminal.
•
Check if there are any broken
signal wires.
•
Check if the logic is correct.
•
If there is a delay in operation,
adjust the time set in Brake
Error Detection Time
(3020-51 hex).
Event code 389D0000 hex
Detection tim-
ing
Error reset Log category
Motor stops.
EtherCAT LINK/ACT
---
Name
None
Prevention
Set the forced stop signal STOP
appropriately.
Appropriately wire and set the
digital input terminal to which the
brake check signal BRKE is as-
signed and the digital output ter-
minal to which the brake signal
BRKS is assigned.
M1 Series EtherCAT Type User's Manual (I670)
Continuously
System log