Omron M1 Series User Manual page 180

4 Inverter Control
 Frequency Reference
Frequency Reference
 Status
The 16-bit data is as shown below.
15 −
Bit
0
1
3
7
9
12
15
−
 Output Frequency Monitor
Output Frequency Monitor
4-6
Name
Specify the frequency reference in increments of 0.01 Hz. When a val-
ue is set that exceeds the maximum frequency, operation is performed
at the maximum frequency.
Setting range: 0 to maximum frequency
− 12 − −
Name
During forward operation
During reverse operation
Fault
Warning
Remote
Frequency matching
Connection error between
EtherCAT communications
CPU and inverter CPU
Reserved
Name
Displays the output frequency in increments of 0.01 Hz.
Meaning
9 − 7 − −
0: Stopped/during reverse operation
1: During forward operation
0: Stopped/during forward operation
1: During reverse operation
0: No alarm (9-1-2 Alarm Code List on page 9-3) occurred
for the inverter
1: Alarm occurred for the inverter
0: No warning (9-1-3 Minor Fault Code List on page 9-25)
occurred for the inverter
1: Warning occurred for the inverter
0: Local (Operations from EtherCAT are disabled)
1: Remote (Operations from EtherCAT are enabled)
0: During acceleration/deceleration or stopped
1: Frequency matched
0: Normal
1: Error (Cannot update data between EtherCAT CPU and
inverter CPU. To restore, turn the power supply OFF and
then ON again.)
Set 0.
Meaning
M1 Series EtherCAT Type User's Manual (I670)
− 3 − 1
Meaning
0