Configuring The Ethernet Link On The Arn - Nortel CC MIS User Manual

May 2007

Configuring the Ethernet link on the ARN

After you complete the procedures in this section, the router can
communicate with the network management station over the IP network.
You are then ready to install the Site Manager software, as described in the
next section.
Each procedure step requires you to do one of the following things:
Enter a number that corresponds to a selection.
Enter y for Yes; n for No; q for Quit.
Enter a word or phrase referred to as a text string.
Press <Return> to accept the default displayed in square brackets [].
You must press the Return key after entering one of the previous responses.
Connecting to the IP network
When you obtained your router, you also received a cable to connect the
router to your IP network.
To connect the cable from the router to the IP network, follow the steps in
Procedure 71.
Procedure 71:
1 Connect the cable to a router connector.
2 Connect the cable to the network connector.
Note: Ensure the cable is connected to the 10Base-T or AUI interface as
described in "Connecting a management console" on page 372. The
network connection depends on your LAN or WAN configuration.
CC MIS Installation and Maintenance
Connecting router cable
TCP/IP switch links using ARN
379