Nortel CC MIS User Manual page 402

TCP/IP switch links using ARN
Adding a new X.25 link
You can use the steps in Procedure 79 to configure the first X.25 link on the
ARN router and to configure additional links on an already operational
ARN. You must first identify the COM port on the ARN to which the cables
for this link will be attached. This COM port should be marked as unused in
the main Configuration Manager window.
Procedure 79:
1 In the Configuration Manager window, click the COM port to which the
DMS link will connect.
The Add Circuit window appears (see Figure 138 on page 402). This
window provides a default name for the new circuit (for example, S11 for
the COM1 port), which identifies the physical location of the port. Nortel
recommends that you accept the default circuit name.
Figure 138:
2 Click OK.
The WAN Protocols window appears (see Figure 139 on page 403).
402
Adding a new X.25 link
Add Circuit window
Call Center Management Information System
Standard 2.0