Command Menu Options; Live Link; Figure 6.5 Switch Link Configuration Screen - Live Link - Nortel CC MIS User Manual

Release 5.2
Switch Codes
The Switch Code field allows
three additional digits to be
prepended to all directory
numbers (DNs) received from
the switch. This field is normally
left blank. This field should be
used if you are using the CC MIS
networking feature in a private
network where duplicate DNs
appear on more than one switch.
Using a unique switch code for
each switch in the private
network, CC MIS can make the
duplicated DNs unique, thereby
allowing the CC MIS
networking feature to operate
properly.
CC MIS Maintenance Guide

Command menu options

The Switch Link Configuration screen has the following commands
on the commands menu:
• Exit
• Clear the form
• Read an existing link definition
• Save link definition
• Delete an existing link definition

Live link

If live is chosen as the link type, the remainder of the fields are dis-
played on the screen. The switch link configuration screen for a live
link appears as shown in Figure 6-5.
Live link definitions are specified to obtain a live connection to the
DMS/MSL-100.

Figure 6.5 Switch link configuration screen - live link

The Reinit Time field is used to specify a time (in 24-hour format) that
the system will request re-initialization from the switch. This field is
left blank when no daily re-initialization is required.
The secondary link field is available only if the link redundancy option
is enabled on the load tape. It can be left blank if link redundancy is
not desired for this live link definition.
Time for the system is set and timezone differences are adjusted using
the Synchronize to Switch Time and Timezone Adjustment fields.
CC MIS
CC MIS
6-9