Nortel CC MIS User Manual page 378

TCP/IP switch links using ARN
Before starting the ARN, install the flash memory card supplied with the
router by following the steps in Procedure 70.
Procedure 70:
1 Position the card with the label facing up and the INSERT arrow pointing
toward the card receptacle.
2 Insert the card into the receptacle.
Figure 132 shows how to insert the flash memory card in an ARN.
3 Gently push the card until it fits snugly into place.
Note: If the card is new and you did not obtain it from Nortel, you must
format the card before you write to it. You can format the card using Site
Manager or the format command available with the Bay Networks
Technician Interface.
Figure 132:
Note: For instructions, see the Using Technician Interface Software manual .
This manual is available at the following Web site:
http://www25.nortelnetworks.com/library/tpubs/nav/router/soft1420.htm
378
Installing the flash memory card
Inserting the flash memory card in the ARN receptacle
Call Center Management Information System
Standard 2.0