Wallboard Messages - Nortel CC MIS User Manual

May 2007

WALLBOARD messages

Introduction
This section contains error messages generated by the Wallboard Process of
the CC MIS product. The Wallboard Process writes the messages to their
'Standard Error' device. The error messages may contain [XX] and/or
'YYYY', which denote any numeric and/or string, respectively.
This section lists only those messages which are unique to the Wallboard
Process. Messages listed in "Standard error messages" on page 456 may
also be generated by this process.
Fatal error messages
Fatal error messages are generated by a Wallboard process in response to
conditions which prevent the process from continuing normal execution.
This section lists these error messages.
Invalid baud rate
An invalid baud rate was specified on the command line. This error message
is only possible in the debugging version of the software. (Action Code: B)
invalid arguments passed
Invalid parameters were specified on the command line that was used to start
the wallboard process. (Action Code: B)
CC MIS Installation and Maintenance
System Log messages
551