Addendum To Ntp 241-9501-501 Vector Switch Hardware Maintenance Guide; Replacing Link Modules - Nortel V2 Release Note

8
Addendum to NTP 241-9501-501 Vector Switch Hardware
Maintenance Guide
This addendum contains the following procedures: replacing link modules,
removing a link select card and installing a link select card.

Replacing link modules

Link modules are hot-swappable, so that they can be removed and replaced on
a switch that is inservice providing the procedure is performed on the inactive
side of the subswitch. Make sure that you have been directed by a switch
operator before performing this procedure.
Replacing link modules
Tools and equipment required:
•
•
•
Answer Y to the following message:
Are you sure you want to manually switch activity [n]?
Synchronize the switch to the newly active fabric by entering the command:
localhost::> operation sync
Answer Y to the following message:
Are you sure you want to sync the switch [n]?
Answer Y to the following message:
Do you wish to wait till your action is complete [y]?
CAUTION
Loss of service
Any action performed on a live switch can result in loss of service.
Before starting work, make sure you have located the correct
component, that you are working on the inactive side of the subswitch,
and that the network operator is aware of your actions.
static wrist wrap
slot head screwdriver
replacement link module
CAUTION
Use a grounding strap when handling any electronic component.
Magellan Vector 2.0 Release Notes, Issue 1.9.1
25