Nortel CC MIS User Manual page 42

CC MIS requirements
Table 5:
IP ports used by the CC MIS application for inbound connections
(Part 4 of 4)
Protocol/port IP interface Name
TCP/202XX
Setting up the standard SNMP agent
As mentioned in the section "Checking for required packages" on page 36,
the optional SNMP feature within CC MIS relies on the Linux SNMP
package (net-snmp) to provide support for MIB-2. By default, installation of
the net-snmp package does not start the standard SNMP agent. If MIB-2
support is required, you must configure the standard SNMP agent to run
when the server is booted.
You can configure the standard SNMP agent to start when the server is
booted by editing the /etc/init.d/snmpd service initialization file. Ensure that
the line near the top of this file that begins with # chkconfig: appears as
follows:
# chkconfig: 2345 50 50
The entry
enters run levels 2 through 5.
After you edit the /etc/init.d/snmpd service initialization file, use the
chkconfig
follows:
chkconfig snmpd reset
42
Any N/W Load
Management
indicates that the SNMP agent starts whenever the system
2345
command to configure the startup of the SNMP agent as
Description
A CC MIS NAP uses this port to
perform load management
operations on a partition being
monitored by the NAP.
The XX value in the port number
represents the partition number of
the partition that is listening on the
port.
Call Center Management Information System
Standard 2.0