Static Lan Terminals - Nortel CC MIS User Manual

Local partitions

Static LAN Terminals

Each partition can have a set of datafilled LAN IP addresses that are
connected as supervisor stations for that partition. Use the Static LAN
Terminals screen to enter these IP addresses.
The following limitations apply to the Static LAN Terminals screen:
Two partitions cannot share the same IP address.
There is no limit to the number of static LAN terminal IP addresses that
you can define on this screen. However, the number of active terminals is
limited at run time by the Max Supervisor Connections parameter.
Adding LAN Terminals
Perform the steps in Procedure 38 to access the Static LAN Terminals
screen to add LAN clients.
Procedure 38:
1 Access the Maintenance and Administration main menu.
2 Type c to access the Configuration main menu.
The system displays the Configuration main menu.
3 Select Get Access Updates Rights to switch to Updates Allowed mode.
4 Select Partition Configuration.
The system displays the Partition Configuration screen.
5 Select the Configuration Options function key
The system displays the Configuration Options menu.
6 Select Static LAN Terminals.
The system displays the Static LAN Terminals screen.
7 Press the Add function key.
The Add pop-up menu appears (see Figure 66).
236
Adding Static LAN terminals
Call Center Management Information System
Standard 2.0