Nortel CC MIS User Manual page 83

May 2007
Standard definitions installation:
Installation of standard definitions completed.
The system displays the following license keycode messages:
A license keycode must be installed before the CC MIS
system can be started. The license keycode enables the
options that were purchased for use with this system.
You must have a keycode that was generated
specifically for this system which has the serial
number listed below:
System Serial Number: XXXXXXXX
Note: The System Serial Number is derived from the MAC address.
Do you wish to install a keycode at this time?
(yes/no)
18 Type y to install the license keycode.
The system continues to display the license keycode messages:
You must now supply the keycode you received to
activate the options/capacities you purchased. This
keycode consists of five blocks of four characters.
Note: You must type the keycode EXACTLY as you
received it. The case of the letters in the keycode is
important.
Once entered, the keycode will be validated and the
features enabled by it will be displayed, allowing you
to confirm that the keycode was entered correctly.
CC MIS Installation and Maintenance
Installing CC MIS
83