Software Installation Of Wlan Location Engine 2340; Network Requirements; Rack Installation - Nortel 2340 Installation Manual

Software Installation of WLAN
Location Engine 2340

Network requirements

For the proper operation of LE, following are the network requirements:
• It should be connected to the wired backbone and should have a statically assigned IP address.
• Each sensor must be assigned a static IP address.
• It must be able to access the wire-side interface of the sensors and a configuration client through the
following connections:
Source Device Source Port
Appliance
Sensors
Configuration
Client
Configuration
Client (admin)

Rack Installation

For illustrated instructions, see
Note.
Use the hardware supplied with your specific rack if it is different from the hardware
supplied in this kit.
Table 6: Connections to access WLE2340
Destination
Device
any, (*) Sensors
UDP 37008 Appliance
any, (*) Appliance
any, (*) Appliance
"L-Bracket Mount Kit Installation Instructions" on page 30
Destination
Port
UDP 37008
any, (*)
TCP 443
TCP 8003
Nortel WLAN — Location Engine 2340 Installation
Purpose
Communication
Communication
HTTPS
HTTPS
chapter in this manual.
33