Performing Acceptance Testing; Performing A Call Test - Nortel CS 1000M HG Manual

To conduct the acceptance testing, make sure that the Remote IPE at
the remote site contains at least one IPE (line) card with at least two
telephones connected to its subscriber loops. If possible, use some analog
(500/2500-type) to check the ringing generator and some digital sets to
check the dual tone multifrequency (DTMF) operation.
Also, make sure that an MMI terminal is connected to the MMI port through
the Fiber Remote Multi-IPE Interface unit.

Performing acceptance testing

Since functions and features at the Remote IPE site are identical to
functions and features at the local site, the main purpose of acceptance
testing is to verify that fiber-optic equipment is functioning correctly. This
can be accomplished by:
•
•
•
Voice calls
A voice call can be established between two voice terminals (telephones)
across a network, between two telephones on the same PBX, and even
between two telephones on the same line card.
Acceptance testing of Remote IPE voice calls is conducted when testing
the following basic system features supported by telephones connected to
subscriber loops at the remote site:
•
•
Placing a call to the remote site
To perform a call test, follow the steps in
test" (page
Procedure 29

Performing a call test

Step
1
Copyright © 2007, Nortel Networks
.
performing basic voice calls
using the MMI terminal to configure and maintain Remote IPE and Fiber
Remote Multi-IPE Interface equipment
checking the protection switching of the fiber-optic link
placing a call to the remote site
placing a call in call hold/call retrieve
107).
Action
From a telephone at the local site, dial a telephone at the Remote
IPE site and establish an active call connection.
Note: The local system treats Remote IPE subscriber loops as
local loops; therefore, it is only necessary to dial the extension
number to access that station.
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 01.01 Standard
Release 5.0 30 May 2007
Performing acceptance testing 107
Procedure 29 "Performing a call