Nortel DMS-100 Series Replacement Procedures page 537

in an RSC-S (PCM-30) Model B RCO2
24
Seat and lock the card.
a Using your fingers or thumbs, push on the upper and lower edges of the
faceplate to ensure that the card is fully seated in the shelf.
b Close the locking levers.
At the MAP terminal
25 Load the DCH card by typing
>LOADPM
and pressing the Enter key.
26 Use the following information to determine the next step in this procedure.
If load
passed
failed
DMS-100 Family NA100 Card Replacement Procedures Volume 6 of 7 LET0015 and up
XPM card replacement procedures (continued)
CAUTION
Loss of subscriber service
Subscriber service may be lost in the active unit when
reseating the NTBX02 card.
It is recommended that this procedure be performed during
low traffic periods.
Do
step 27
step 34
1-505
NTBX02
(continued)