Nortel DMS-100 Series Replacement Procedures page 99

Hide thumbs Also See for DMS-100 Series:

Table of Contents

To determine the location of the RCO2 that contains the NT6X92 circuit card

you are to replace, type:

and press the Enter key.

Example of a MAP response:

PM Type: RCO2 PM No.: 0 PM Int. No.: 9 Node_No: 24

PMs Equipped: 53 Loadname: UK00ADU6 EEPRom Load:

WARM SWACT is supported and available

RCO2 0 is included in the REX schedule.

REX on RCO2 0 has not been performed.

Node Status: {OK, FALSE}

Unit 1 Inact, Status: {OK, FALSE}

Site Flr RPos Bay_id Shf Description Slot EqPEC

Determine the state of the RCO2 unit for the circuit card you are to replace.

If the state of the RCO2 unit

To switch activity (SWACT) of the units, type:

and press the Enter key.

Example of a MAP response:

DMS-100 Family NA100 Card Replacement Procedures Volume 6 of 7 LET0015 and up

XPM card replacement procedures (continued)

Status: {OK, FALSE}

01:13 MX86AA