Nortel DMS-100 Series Replacement Procedures page 235

Hide thumbs Also See for DMS-100 Series:

Table of Contents

At the RCE frame

Put on a wrist strap.

Remove the NT7X05 card as shown in the following ﬁgures.

Locate the card to be removed on the appropriate shelf.

Open the locking levers on the card to be replaced and gently pull the

card towards you until it clears the shelf.

DMS-100 Family NA100 Card Replacement Procedures Volume 6 of 7 LET0015 and up

XPM card replacement procedures (continued)

in an RSC-S (DS-1) Model A RCC2

Static electricity damage

Before removing any cards, put on a wrist strap and connect

it to the wrist strap grounding point on the left side of the

frame supervisory panel of the RCC2. This protects the

equipment against damage caused by static electricity.

Equipment damage

Take the following precautions when removing or inserting a

1. Do not apply direct pressure to the components.

2. Do not force the cards into the slots.