Nortel DMS-100 Series Replacement Procedures page 308

Hide thumbs Also See for DMS-100 Series:

Table of Contents

1-276 XPM card replacement procedures (continued)

At the frame

297-8021-547 Standard 14.02 May 2001

Static electricity damage

Before removing any cards, put on a wrist strap and connect

it to the wrist strap grounding point on the left side of the

frame supervisory panel of the SMS-R. This protects the

equipment against damage caused by static electricity. Do

not replace more than one 8X18 card at a time.

Equipment damage

Take the following precautions when removing or inserting a

1. Do not apply direct pressure to the components.

2. Do not force the cards into the slots.

Put on a wrist strap.

Remove the NT8X18 card as shown in the following ﬁgures.

Locate the card to be removed on the appropriate shelf.

Open the locking levers on the card to be replaced and gently pull the

card toward you until it clears the shelf.