Nortel DMS-100 Series Replacement Procedures page 933

At the MAP terminal
4 Busy the inactive ESA processor by typing
>BSY
and pressing the Enter key.
Example of a MAP response:
ESA 4
Please confirm ("YES", "Y", "NO", or "N"):
Respond by typing
>YES
At the RLCM frame
5
Put on a wrist strap.
6 Remove the NTMX45 card as shown in the following figures.
a Locate the damaged card on the appropriate shelf.
DMS-100 Family NA100 Card Replacement Procedures Volume 6 of 7 LET0015 and up
XPM card replacement procedures (continued)
This action will take this PM
out of service
WARNING
Static electricity damage
Before removing any cards, put on a wrist strap and connect
it to the wrist strap grounding point on the left side of the
frame supervisory panel of the LCM. This protects the
equipment against damage caused by static electricity.
DANGER
Equipment damage
Take the following precautions when removing or inserting a
card:
1. Do not apply direct pressure to the components.
2. Do not force the cards into the slots.
in an RLCM HIE
1-901
NTMX45
(continued)