Nortel DMS-100 Series Replacement Procedures page 658

1-626 XPM card replacement procedures (continued)
NTBX34
in an RSC-S (PCM-30) Model A LCME
At the LCE frame
5
6
297-8021-547 Standard 14.02 May 2001
DANGER
Equipment damage
Take these precautions when removing or inserting a card:
1. Do not apply direct pressure to the components.
2. Do not force the cards into the slots.
WARNING
Card damage—transport
Take these precautions to protect the circuit cards from
electrical and mechanical damage while transporting cards.
When handling a circuit card not in an electrostatic discharge
(ESD) protective container, stand on a conductive floor mat
and wear a wrist strap connected, through a 1-megohm
resistor, to a suitably grounded object, such as a metal
workbench or a DMS switch frame (Northern Telecom
Corporate Standard 5028).
Store and transport circuit cards in an ESD protective
container.
Put on a wrist strap.
Remove the NTBX34 card as shown in the following figures.
a Locate the card to be removed on the appropriate shelf.
(continued)