Nortel DMS-100 Series Replacement Procedures page 909

and pressing the Enter key.
If the LOADFW UPGRADE
passes
fails
31 Return the ESA to service by typing
>RTS
and pressing the Enter key.
If the RTS
passes
fails
32 Send any damaged cards for repair according to local procedure.
33 Record the following items in office records:
• date the card was replaced
• serial number of the card
• problems that required replacement of the card
Go to step 36.
Return to the Alarm Clearning Procedure that referred you to this procedure.
34
If necessary, go to the point where the damaged card list was produced,
identify the next damaged card on the list, and go to the appropriate
procedure for that card in this manual.
35 Contact the next level of support for additional help to replace this card.
36 You have completed this procedure. Return to the maintenance procedure
that referred you to this card replacement procedure and continue.
DMS-100 Family NA100 Card Replacement Procedures Volume 6 of 7 LET0015 and up
XPM card replacement procedures (continued)
Do
step 31
step 35
Do
step 32
step 35
NTMX45
in an IOPAC HIE
1-877
(end)