Nortel DMS-100 Series Replacement Procedures page 312

Hide thumbs Also See for DMS-100 Series:

Table of Contents

1-280 XPM card replacement procedures (continued)

297-8021-547 Standard 14.02 May 2001

Return to Alarm Clearing Procedures section of this manual or to the

procedure that directed you to this procedure. At the point where a faulty card

list was produced, identify the next faulty card on the list and go to the

appropriate card replacement procedure for that card in this manual.

Obtain further assistance in replacing this card by contacting personnel

responsible for a higher level of support.

You have successfully completed this procedure. Return to the maintenance

procedure that directed you to this card replacement procedure and continue

as directed.

For further assistance with switch of activity, contact the personnel

responsible for the next level of support.

Note: If the system recommends using the SWACT command with the

FORCE option, consult ofﬁce personnel to determine if use of the FORCE

option is advisable.