Nortel DMS-100 Series Replacement Procedures page 780

Hide thumbs Also See for DMS-100 Series:

Table of Contents

1-748 XPM card replacement procedures (continued)

in an RSC LCM

At the shelf

297-8021-547 Standard 14.02 May 2001

Static electricity damage

Wear a wrist strap that connects to a wrist-strap grounding

point to handle circuit cards. The wrist-strap grounding point

is on a frame supervisory panel (FSP) or a modular

supervisory panel (MSP). The wrist strap protects the cards

against static electricity damage.

Risk of equipment damage

Take these precautions when removing or inserting a card:

1. Do not apply direct pressure to the components.

2. Do not force the card into its slot.

Risk of equipment damage

Proceed only if a step in a maintenance procedure directs you

here. If you perform this procedure without permission,

equipment damage can occur.

Risk of electrocution

Proceed only if a step in a maintenance procedure directs you

here. If you perform this procedure without permission,

personal injury can occur.

Put on a wriststrap.

Note 1: A card shroud is required to insert or remove an NTEX17 card in

line drawers. This is a 6-inch (152 mm) card, and requires the card shroud

with appratus code QTH58A and common product code A0313317.

Note 2: A card removal tool is required to remove the NTEX17 card from

line drawers. The appratus code for the grip tool is QTH57A, and the

common product code is A0298292. You can also use the large grip tool