Nortel DMS-100 Series Replacement Procedures page 132

Hide thumbs Also See for DMS-100 Series:

Table of Contents

1-100 XPM card replacement procedures (continued)

in an RSC-S (PCM-30) Model A RCO2

At the RCE frame

297-8021-547 Standard 14.02 May 2001

Static electricity damage

Before removing any cards, put on a wrist strap and connect

it to the wrist strap grounding point on the left side of the

modular supervisory panel of the RCO2. This protects the

equipment against damage caused by static electricity.

Equipment damage

Take these precautions when removing or inserting a card:

1. Do not apply direct pressure to the components.

2. Do not force the card into its slot.

Put on a wrist strap.

Remove the NT6X92 card as shown in the following ﬁgures.

Locate the card to be removed on the appropriate shelf.

Open the locking levers on the card to be replaced and gently pull the

card toward you until it clears the shelf.