Nortel DMS-100 Series Replacement Procedures page 574

1-542 XPM card replacement procedures (continued)
NTBX26
in an RSC LCME
At the LCE frame
5
297-8021-547 Standard 14.02 May 2001
(continued)
WARNING
Card damage—transport
Take these precautions to protect the circuit cards from
electrical and mechanical damage while transporting cards.
When handling a circuit card not in an electrostatic discharge
(ESD) protective container, stand on a conductive floor mat
and wear a wrist strap connected, through a 1-megohm
resistor, to a suitably grounded object, such as a metal
workbench or a DMS switch frame (Northern Telecom
Corporate Standard 5028).
Store and transport circuit cards in an ESD protective
container.
DANGER
Equipment damage
Take these precautions when removing or inserting a card:
1. Do not apply direct pressure to the components.
2. Do not force the cards into the slots.
DANGER
Hot materials
Exercise care when handling the line card. The line feed
resistor may be very hot.
CAUTION
Special tools required
Card shrouds and removal tools are required for removing
cards from the line drawers.