Figure D.1-3 Memory Map In Prom Mode (Mb89P135A) - Fujitsu F2MC-8L Series Hardware Manual

Programming to PROM
Programming procedure for MB89P131
1. Set the EPROM programmer to the MBM27C256A.
2. Load program data into the EPROM programmer at 7000
F000
H
mode).
3. Program with the EPROM programmer.
Programming procedure for MB89P133A
1. Set the EPROM programmer to the MBM27C256A.
2. Load program data into the EPROM programmer at 6000H to 7FFF
E000
H
mode).
3. Program with the EPROM programmer.
Programming procedure for MB89P135A
1. Set the EPROM programmer to the MBM27C256A.
2. Load program data into the EPROM programmer at 4000H to 7FFF
C000
H
mode).
3. Load option data into addresses 3FF0
4. Program with the EPROM programmer.

Figure D.1-3 Memory Map in PROM Mode (MB89P135A)

Normal operation
(MB89P135A)
0000
H
Not available
8000
H
Not available
8FF0
H
Not available
8FF6
H
Not available
C000
H
Program area
(PROM)
FFFF
H
to FFFF while operating as a single chip assign to 7000
H
to FFFF while operating as a single chip assign to 6000
H
to FFFF while operating as a single chip assign to 4000
H
PROM mode
(Corresponding addresses on
the PROM programmer)
I/O
RAM
0000
H
Not available
3FF0
H
3FF6
H
Not available
4000
H
Program area
7FFF
H
to 3FF6 of the EPROM programmer.
H H
APPENDIX D Programming PROM
Option area
(EPROM)
to 7FFF (note that addresses
H H
to 7FFF
H
(note that addresses
H
to 7FFF
H
(note that addresses
H
to 7FFF
H
in EPROM
H
in EPROM
H
in EPROM
H
331