Fujitsu F2MC-8L Series Hardware Manual page 315

CHAPTER 13 REMOTE-CONTROL TRANSMISSION FREQUENCY GENERATOR
Table 13.4-2 Functions of Remote-control Transmission Frequency Control Register 2 (RCR2) Bits
No.
Bit 5
Bit 4
Bit 3 SCL5 to SCL0:
Bit 2 Frequency setting bits
Bit 1
Bit 0
288
Bit name
Set the cycle count of the remote-control transmission frequency,
which is to be compared with the counter value. (Value compared
for cycle)
Note:
In case of selecting 0.5 t
between "01 " and "3F
H
preceding pin state until the counter value reaches the value
compared for "H" width. And the output level keeps "H" after
the bit value equals to the counter value reaches the value
compared for "H" width.
In case of selecting 1/8/32 t
bits between "02 " and "3F
H
holding the preceding pin state until the counter value reaches
the value compared for "H" width. And the output level keeps
"H" after the bit value equals to the counter value reaches the
value compared for "H" width. Setting these bits to "01
the value for "H" width to "00
selected count clock cycle and the output level becomes "H" of
0.5 t .
inst
Function
(internal count clock), set these bits
inst
". Setting the bits to "00
H
(internal count clock),set these
inst
". Setting the bits to "00
H
", the operation is based on the
H
", holding the
H
",
H
" and
H