Fujitsu F2MC-8L Series Hardware Manual page 259

8-bit microcontroller

Hide thumbs Also See for F2MC-8L Series:

Table of Contents

CHAPTER 10 EXTERNAL INTERRUPT CIRCUIT 1 (EDGE)

Interrupt requests from external interrupt circuit 1

This interrupt request is generated if interrupt request output has been enabled

(EIC1: EIE0 = "1") when a edge with a selected polarity is input to the external

interrupt input pin INT0.

This interrupt request is generated if interrupt request output has been enabled

(EIC1: EIE1 = "1") when a edge with a selected polarity is input to the external

interrupt input pin INT1.

This interrupt request is generated if interrupt request output has been enabled

(EIC2: EIE2 = "1") when a edge with a selected polarity is input to the external

interrupt input pin INT2.