Fujitsu F2MC-8L Series Hardware Manual page 313

CHAPTER 13 REMOTE-CONTROL TRANSMISSION FREQUENCY GENERATOR
Table 13.4-1 Functions of Remote-control Transmission Frequency Control Register 1 (RCR1) Bits
Bit name
Bit 5
Bit 4
Bit 3 HSC5 to HSC0:
Bit 2 "H" width setting bits
Bit 1
Bit 0
286
Set the "H" width count of the remote-control transmission
frequency ("H" width compare value), which is to be compared
with the counter value.
Note:
In case of selecting 0.5 t
a value between "00
value. The output level becomes "H" when the bit value
equals to or greater than the cycle value.
In case of selecting 1/8/32 t
set a value between "01
cycle value. The output level becomes "H" of 0.5 t
these bits are "00 "; it becomes "H" when the bit value equals
H
to or greater than the cycle value.
Function
(internal count clock),be sure to set
inst
" and "3E " that is smaller than the cycle
H H
(internal count clock),be sure to
inst
" and "3E " that is smaller than the
H H
,when
inst