Standalone Eprom Mode - Fujitsu F2MC-8L Series Getting Started

MB89201 Series – Getting Started
Chapter 5 Standalone EPROM Mode

5 Standalone EPROM Mode

This chapter gives some explanations for the standalone EPROM mode.
The evaluation board FMPDC-MB89V201-ADPB can be used as a standalone board without
the emulator. Therefore you need to program the execution code to an external EPROM.
Used with this board is the EPROM 27C256. Program this EPROM with an EPROM
programmer, for example the GALEP-4 programmer. You have to map the code area from
0x8000 to 0xFFFF to this EPROM.
Memory Map
Mount the EPROM on the socket on the evaluation board. Remove jumper plug J1 and set
SW1-3 to ON. Additionally set jumper plug J2 and SW1-4 to ON for use off the on-board
reset button.
Pin 1
© Fujitsu Microelectronics Europe GmbH - 15 - MCU-AN-300000-E-V11