Tasks - Avaya S8100 Series Manual

Tasks

Perform the tasks in this section at the customer site.
Go to the standard documentation
Use Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media
Server, 555-234-100, Issue 9, February 2006.
To upgrade the S8300, you complete selected tasks from Chapter 12. You need to complete
only some of the tasks in these chapters. The page number associated with specific tasks are
located in the left column. The subtasks to perform or skip are listed in the right column.
Note where the task is performed. Most of the tasks are done on a server. The server is either
the S8300 or the primary controller for the S8300 when the S8300 is configured as an LSP.
The following headings indicate on which of these devices the task is performed.
1. If IA770 is in use (ICC
mode), get IA770 data and
stop IA770.
See "Getting IA770
(AUDIX) Data and
Stopping IA770
(if IA770 is being used)" in
Chapter 12.
2. Backup all system files —
translations, OS, and
security backup sets.
See "Backing up S8300
recovery system files" in
Chapter 12.
3. Install preupgrade service
pack (R2.x only)
See "Copying and
installing the service pack
files to the media server
(starting from R2.x only)"
in Chapter 12.
Task
On the S8300 (ICC or LSP)
Steps/Comments
ICC mode: Do not restore these backup sets on the
S8300B. However, back up these sets in case it is
necessary to revert to the original configuration.
LSP mode: Backup only OS and security sets. These
backup sets will not be restored on the S8300B. Back
up the sets in case it is necessary to revert to the
original configuration.
You must install this service pack to enable the S8300B
Web Interface to upload and install the CM 3.1
software.
Tasks
1 of 4
Issue 2.1 June 2006 85