Removing And Replacing The Chassis Cover On J2320 And J2350 Routers - Juniper J-series Services Router J4350 Getting Started Manual

Juniper networks services router getting started guide
Hide thumbs Also See for J-series Services Router J4350:
Table of Contents

Advertisement

J2320, J2350, J4350, and J6350 Services Router Getting Started Guide
3.
4.
5.
6.
7.
NOTE: In the
as an FPC number and the PIM number (always 0) is reported as a PIC number. For
more information about network interface naming, see J-series Services Router Basic
LAN and WAN Access Configuration Guide.

Removing and Replacing the Chassis Cover on J2320 and J2350 Routers

On J2320 and J2350 routers, the chassis cover fits tightly on the chassis. To remove
the cover from the chassis:
1.
2.
3.
4.
176

Removing and Replacing the Chassis Cover on J2320 and J2350 Routers

Arrange the cable as necessary to prevent it from dislodging or developing stress
points:
Secure the cable so that it is not supporting its own weight as it hangs to the
floor.
Place excess cable out of the way in a neatly coiled loop.
Use fasteners to maintain the shape of cable loops.
Insert the other end of the cable into the destination port.
Repeat the previous steps for any additional cables.
If the PIM is offline (its status LED is steadily red), issue the following CLI
command to bring the PIM online:
user@host> request chassis fpc slot pim-slot online
For example, to bring the PIM in slot 4 online, enter the following command:
user@host> request chassis fpc slot 4 online
For more information about the command, see the JUNOS System Basics and
Services Command Reference.
Verify that the PIM status LED shines steadily green to confirm that the PIM is
online.
You can also verify correct PIM functioning by issuing the
pic-status
command described in the JUNOS System Basics and Services Command
Reference.
show chassis fpc pic-status
Press and release the power button to power off the router. Wait for the
LED to turn off.
Remove the power cable from the power source receptacle.
With a Phillips screwdriver remove the grounding screw.
Remove the router from the rack.
show chassis fpc
command, the PIM slot number is reported
POWER

Advertisement

Table of Contents
loading

This manual is also suitable for:

J6350J2350J2320

Table of Contents