Disconnecting Power On An Ac-Powered M10I Router; Connecting Power On An Dc-Powered M10I Router - Juniper M10i Hardware Manual

Related
Documentation

Disconnecting Power on an AC-Powered M10i Router

Related
Documentation

Connecting Power on an DC-Powered M10i Router

Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com
NOTE: After powering off a power supply, wait at least 60 seconds before
turning it back on.
M10i AC Power Supply Description on page 25
M10i Router AC Power Supply Specifications on page 191
Connecting to a Management Console or Auxiliary Device on page 62
Connecting to a Network for Out-of-Band Management on page 62
Preventing Electrostatic Discharge Damage to an M10i Router on page 150
General Electrical Safety Guidelines and Electrical Codes for M10i Routers on page 167
To disconnect AC power from the router:
Power off the router. See "Powering Off an M10i Router" on page 71.
1.
Press the power switch on each power supply faceplate to the
2.
Unplug the AC power cord from each power supply.
3.
NOTE: When multiple AC power supplies are installed in the chassis, all
AC power cords (one for each power supply) must be unplugged to
disconnect power completely.
Preventing Electrostatic Discharge Damage to an M10i Router on page 150
General Electrical Safety Guidelines and Electrical Codes for M10i Routers on page 167
M10i AC Power Supply Description on page 25
M10i Router AC Power Supply Specifications on page 191
On a DC-powered router, the DC power cables from the external DC power sources
connect to field-wiring terminals on each power supply.
Connect DC power to the router by inserting power cables into the field-wiring terminals
on the faceplate of each power supply. DC power cables are not supplied with the router.
For information about the required cable type, see "M10i DC Power Cable and Lug
Specifications" on page 192.
Chapter 11: Providing Power to the M10i Router
( ) position.
OFF O
67