Table of Contents
Advertisement
Refitting the complete engine
Fit and fasten the heat shields (37) over the engine
mounting bushes on both sides, tightening the
screws indicated.
Tightening torque
Screw
Tighten the screw indicated on the ground cable
(38) onto the engine and secure the cable to the
indicated fastener clamp on the starter motor
shield.
Tightening torque
Screw
Fit the left hand removable subframe (34) in the
relative seat on the chassis.
From underneath, tighten the two screws indicated
fastening the secondary air pump mounting
bracket to the left hand removable subframe (34).
Fit the secondary air pipe (46) onto the pump inlet
and fasten by fitting a new clamp as indicated.
Page 6 of 30
Nm
Class
9 Nm
B
Nm
Class
18 Nm
B
Advertisement
Table of Contents
