Table of Contents
Advertisement
Shock absorbers
Clean the mating surfaces with a degreasing
product (heptane).
DO NOT use lubricants or electric/pneumatic
drivers.
ALWAYS replace the suspension arm fastener
nuts, complete with relative washers, each
time they are removed.
Replacement is NOT necessary if the nuts are
loosened only.
Tighten the four nuts indicated fastening the upper
arm (B) in the following tightening order: (a), (b),
(c), (d).
Move the shock absorber aside to facilitate the
operation.
Tightening torque
Nut (pretightening)
Nut
Attach the tie-rod for the NRRPS motion sensor (2)
to the upper arm (B).
Tighten the two screws indicated fastening the
shock absorber (A) to the chassis.
Tightening torque
Screw
Page 5 of 16
Nm
Class
9 Nm
A
60 Nm
A
Nm
Class
110 Nm
A
Advertisement
Table of Contents
