Table of Contents
Advertisement
3.3 Replacing the complete vehicle flank
3. Using the AVDEL gun with the 45 mm C frame,
remove the rivets in correspondence with the lower
rear bumper reinforcement and the lateral crash
reinforcement.
NOTE!
Retrieve all the rivets, using a magnet if
necessary, as any remaining rivets will cause
noise when the vehicle is in use.
4. Sand the underdoor weld points on the sill tubular
element and on the A-pillar flange.
Caution!
Check that the front sill pillar casting joints are
free from cracks or buckling.
If any damage is noted, replace the sill (see
chapter 3.5).
Caution!
Take care not to damage the sill tubular
element.
Copyright ©
2010
3
4
4
Advertisement
Table of Contents
